Manual

Procedure

1. Prepare a sketch with the given code and upload it to your

board.

2. Connect the module/component to the board as shown in

the connection diagram or table.

3. Open the Serial Monitor in the IDE and set the Baud rate to

9600.

4. Touch the sensor. The LED goes on and a message (as

given in the code example) is printed to the Serial Monitor.

Specifications

Operating voltage 5 V/DC

Dimensions (approx.) 28 x 15 x 6 mm

Weight (approx.) 2 g

Disposal

Electronic devices are recyclable waste and must not be dis-

posed of in the household waste.

At the end of its service life, dispose of the product in

accordance with applicable regulatory guidelines.

You thus fulfill your statutory obligations and contribute to the pro-

tection of the environment.

Legal Notice

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-

92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method,

e.g. photocopy, microfilming, or the capture in electronic data pro-

cessing systems require the prior written approval by the editor.

Reprinting, also in part, is prohibited.

This publication represent the technical status at the time of printing.