Datasheet

Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau
Datasheet
Item no. 1688482
Matching code operation
If unique-control or new-coded-remote is needed, pairing the remote and the receiver as below operation instruction before using:
1. Step 1: Pressing key “set” and hold on, power on the controller, the load LEDs will be 50% brightness white as responding.
2. Step 2: Continuously to press the key “CT mode “ for 3 times within 5 seconds after step 1 ,the brightness of LEDs will change
from 25% -10% as responding.
3. Code learning successfully, the LEDs will be back to the status before the power off, and the receiver only can be control by the
remote.
4. If not, please re-operate from step 1 to 2.
Clear code operation
Back to factory default, receiver can be controlled by any one the same remote control.
1. Step 1: Pressing key “set” and hold on, power on the controller, the load LEDs will be 50% brightness white as responding.
2. Step 2: Continuously to press “Dynamic mode “ 3 times within 5 seconds after step 1 ,the brightness of LEDs will change from
25% -10% as responding.
3. Code clearing successfully, the LEDs will be back to the status before the power off, and the receiver can be controlled by any
remote control (any one the same remote control can be used to clear the code).
4. If not, please re-operate from step 1 to 2.
Typical Applications
Product information for placing order
Product name
Item number
RF remote controller RGBCCT
TRU-CONRGBCCT-RECRGBCCT