Manual

Off-SeasonStorage
Observe the following when preparing the edger for
long-term storage:
Clean and lubricate unit thoroughly as instructed on
page 10 of this manual.
Refer to the Service,Storage& Specificationssection of
the Briggs & Stratton Owner/Operator Manual
packed with the edger for engine storage
instructions.
Coat the edger blade with chassis grease to
prevent rusting and corrosion.
Store the edger in a dry, clean area. Do not store
next to any corrosive matedals, such as lawn
fertilizer.
Coat the edger, especially any springs and
bearings with a light oil or silicone spray.
IMPORTANT: When storing any type of power
equipment in an poorly ventilated or metal storage
shed, care should be taken to rustproof the equipment.
SECTION7: TROUBLESHOOTING
Trouble Possible Cause(s)
Engine fails to start Dirty air cleaner
Engine runs erratic
Engine needs to be pdmed
Fuel tank empty
Stale fuel in gasoline tank
Throttle control lever not in
starting position
Spark plug wire disconnected.
Spark plug fouled
Engine flooded
Spark plug wire loose
Stale fuel in gasoline tank
Vent in gas cap plugged
Water or dirt in fuel system
Dirty air cleaner
Carburetor out of adjustment
Engine overheats Engine oil level low
Air flow restricted
Dirty air filter
Carburetor not adjusted properly
Excessive vibration Edger blade bent or damaged
Blade spindle bent or damaged
Drive belt slips Belt wom or stretched
Corrective Action
Refer to the Briggs & Stratton Owner/Operator Manual
packed with your unit.
Push primer bulb two or three times.
Fill tank with clean, fresh gasoline.
Drain gasoline and refill tank with clean, fresh gasoline.
Move throttle lever to FAST position.
Connect the spark plug wire to the spark plug.
Clean, adjust gap or replace spark plug.
Refer to the Briggs & Stratton Owner/Operator Manual
packed with your unit.
Connect and tighten spark plug wire.
Drain gasoline and refill tank with clean, fresh gasoline.
Clear vent of any debds.
Drain fuel tank. Refill with fresh fuel.
Refer to the Briggs & Stratton Owner/Operator Manual
packed with your unit.
Refer to the Briggs & Stratton Owner/Operator Manual
packed with your unit.
Fill crankcase with proper oil.
Clean the area around the engine's cooling fins.
Replace the engine's air filter
Refer to the Briggs & Stratton Owner/Operator Manual
packed with your unit.
Replace edger blade.
Contact an authorized MTD service dealer.
Replace drive belt.
12