Manual

MAINTENANCE SCHEDULE
Perform these required maintenance procedures at the
frequency stated in the table. These procedures should
also be a part of any seasonal tune-up.
NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about
these procedures take your unit to any non-road
engine repair establishment, individual or
authorized service dealer.
I_[WARNING: To prevent serious injury,never do
maintenance or repairswith unit running. Always do I
maintenance and repairs on a co01unit. Disconnect
spark pug w re to ensure the unt w not start.
NOTE: Maintenance, replacement, or repair of the
emission control devices and system may be
performed by any non-road engine repair
establishment, individual or authorized service
dealer.
In order to assure peak performance of your engine,
inspection of the engine exhaust port may be necessary
after 50 hours of operation. If you notice lost RPM, poor
performance or general lack of acceleration, this service
may be required. If you feel your engine is in need of this
inspection, refer service to any non-road engine repair
establishment, individual or authorized service dealer for
repair. DO NOT attempt to perform this process yourself
as engine damage may result from contaminants
involved in the cleaning process for the port.
FREQUENCY MAINTENANCE REQUIRED REFER TO
Before starting engine Fill fuel tank with fresh fuel Page 8
Every 10 hours Clean and re-oil air filter Page 15
Check and clean spark arrestor Page i 6
Every 25 hours Check spark plug condition and gap Page 18
Every 50 hours Inspect exhaust port and spark arresto[ screen for clogging or Page 16
obstruction to assure maximum performance levels
LINE INSTALLATION FOR THE SPEEDSPOOL _
wire, Chain, or rope, etc. These can break off
and become dangerous project es.
Always use a genuine original equipment 0.095 inch
(2.41 mm) replacement line. Lines other than those
specified may make the engine overheat or fail.
There are two methods to replace the SpeedSpool ce
trimming line:
Wind the inner reel with new line
Install a pre-wound inner reel
Winding the Inner Reel With New Line
NOTE: It Is unnecessary to remove the bump knob to
install a new trimming line.
1. Cut two pieces of 0.095 inch (2.41 mm) trimming
line, 10 feet (3 m)long.
2. Hold the outer spool and turn the inner reel
counterclockwise to line up the arrows on the outer
spool and inner reel (Fig. 12).
I _1_ ]WARNING: Always use the correctline ]
,_, I length when installing trimming line on the /
_| unit. The line may not release properly if the|
I line is too long. ]
Top View Of The SpeedSpoor
Arrows
Outer Spool
Inner Reel
pKnob
Fig. 12
12