Manual

MAINTENANCE SCHEDULE
Perform these required maintenance procedures at the
frequency stated in the table. I hose procedures should
also be a part of any seasonal tune-up.
NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about
these procedures take your unit to any non-road
engine repair establishment, individual or
authorized service dealer.
NOTE: Maintenance, replacement, or repair of the emission
control devices and system may be performed by
any non-road engine repair establishment, individual
or authorized service dealer.
FREQUENCY MAINTENANCE REQUIRED _ REFERTO
: [
LINE INSTALLATION
I his section covers both SplitLine TM and standard single
line installation.
Always use Genuine Factory I_artsTM 0.105 in. I2.66 ram)
replacement line. Line other than the specified may make
the engine overheat or fail.
2,
3.
4.
I_emove the inner reel from the outer spool (Fig. 32).
I_emove spring from the inner reel (Fig. 32).
Use a clean cloth to clean the the inner reel, spring
shaft and inner surface of the outer spool (Fig. 33).
Check the indexing teeth on the inner reel and outer
spool for wear [Fig. 34). If necessary, remove burrs or
replace the reel and spool.
I here are two methods to replace the trimming line:
• Wind the inner reel with new line
* Install a prewound inner reel
Winding the Existing Inner Reel
1. Holdthe outar spool with one hand and unscrew the
Bump Knob clockwise {Fig. 32). Inspect the bolt inside
the bump knob to make sure i_moves freely. Replace
the bump knob if damaged.
\\
.................................... i i i_i_i_"
Hg+ 3
Indexing
iiiiiiiiiiiiiiiiiiiiiiiiiii _
Bolt
Bump Knob _
i !g;i3Zi