Manual

ShaftGrip

(4) Screws_

Shaft _b.!

Housing I

On/Off Stop Control

Minimum 6 inches

(15.24 cm)

D-Handh

Bottom Clamp

Fig. 1

On some units, the D-handle may be preinstalled and

only require loosening the screws and adjusting the

D-handle to the operator. Go to step 4 for adjusting the

D-handle if preinstalled.

INSTALLING AND ADJUSTING THE D-HANDLE

1. Remove the screws and bottom clamp piece that

were installed on the D-handle for shipping.

2. Place D-handle the over the shaft housing and onto

the bottom clamp (Fig. 1). Place it a minimum of 6

inches (15.24 cm) from the end of the shaft grip.

3. Hold each hex nut in the bottom clamp recess with a

finger. Start screws with a large Flat-head or T-20

Torx screwdriver. Do not tighten until you make the

handle adjustment.

4. If it was preinstalled, loosen the screws on the

D-handle just enough to move the D-handle.

5. While holding the unit in the operating position

(Fig. 2), position the D-handle to the location

that provides you the best grip.

6. Tighten the clamp screws evenly, until the D-handle

is secure.

Fig. 2