Manual

/
OPERATING THE EZ-LINK TM SYSTEM
The EZ-Link rM system enables the use of these
optional add-ons.
Blower/Vacuum .......................... BV720r
Cultivator .............................. GC720r
Edger .................................. LE720r
Hedge Trimmer .......................... HS720r
Snow Thrower ........................... ST720r
Straight Shaft Trimmer .................... SS725r
Sweeper/Blower ......................... SB720r
Tree Pruner ............................. TP720r
Turbo Blower ............................ TB720r
_i WARNING: Read and understand operator's
manual for add-on prior to operation.
Removing the Cutting Attachment or Add-Ons:
1. Turn the knob counterclockwise to loosen (Fig. 10).
2. Press and hold the release button (Fig. 10).
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link rM_ coupler (Fig. 10).
Installing the Cutting Attachment or Add-Ons:
,_ WARNING: To avoid serious personal injury
and damage to the unit, shut unit off before
removing or installing add-ons.
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a work
bench.
1. Turn knob counterclockwise to loosen (Fig. 10).
EZ:LinkTM coupler Release Button
\
Guide Recess
Fig. 10
2. While firmly holding the add-on, push it straight into
the EZ-Link TM coupler (Fig. 11).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 11).
Release Button
EZ-Link TM Coupler
Hole
Upper Shaft Housing /
Lower Shaft HouSing
Fig. 11
3. Turn the knob clockwise to tighten (Fig. 12).
iA C OT'O°: ock here'eo e0uttoo'o hei
primary hole and securely tighten the knob
before operating this unit.
A
90"Edging Hole
180" Edging Hole
Fig. 12
l& AUTION: The cutting attachment and
add-ons with the EZ-Link TM system are to be
used in the primary hole unless stated
otherwise in the specific add-ons operator's
manual. Using the wrong hole could lead to
personal injury, or damage to the unit.
For edging when using the line head cutting attachment
with EZ-Link TM models, lock the release button of the
cutting attachment into the 90 ° edging hole or the 180°
edging hole(Fig. 12).
12