Manual

ASSEMBLING THE COUPLER
The following Troy-Bilt Add-Ons are also available for your unit:
Cultivator ................................ TBGC
Hedge Trimmer ............................ TBHS
Edger .................................... TBLE
Straight Shaft Trimmer ...................... TBSS
Snow Thrower ............................. TBST
Turbo Blower .............................. TBTB
Tree Pruner ................................ TBTP
Removing the add-on
manual for unit to be Used with this add-0n
I_[ WARNING:priorto operation.Readand understand operator's
1. Turn the knob counterclockwise to loosen (Fig. 5).
2. Press and hold the release button (Fig. 5).
3. While firmly holding the upper shaft housing, pull the
blower/vaccuum add-on out of the coupler (Fig. 6).
Installing the add-on
and damage to the unit, shut unit off before
remov ng or nsta ng add-ons.
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a
work bench.
1. Remove the hanger from the top of the shaft housing.
2. Turn knob counterclockwise to loosen (Fig. 5).
3. While firmly holding the add-on, push it straight into
the coupler (Fig. 6).
Coupler Release Button Guide Recess
\
\ \ /
Release Button
Coupler Primary Hole ///
\\
Upper Shaft Lower Shaft
Housing Knob _ Housing
Fig. 6
4. Turn the knob clockwise to tighten (Fig. 7).
IAIc.o,o.Lockthe release button inthe ]
primary hole (Fig. 6) and securely tighten the |
knob before operating this Unit. ]
_Knob
Fig. 7
A CAUTION: The add-ons With the coupler
system are to be used in th e primary hole
only. Using the wrong hole could lead tO
persona njury or damage to the un t.
The blower/vacuum add-on should be installed with the
release button in the primary hole.
Check Flex Shaft Engagement Prior to Using
1. Start the unit.
2. Briefly engage and release the trigger.
3. Check that add-on is operating.
4. If the add-on is not operating, remove add-on and
repeat steps for installing the add-on.
5. Recheck operation of add-on attachment.
Iockwise
Knob
Fig. 5
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 5).
8