Manual

OPERATING THE EZ-LINK TM SYSTEM
The EZ-Link _ system enables the use of these
optional add-ons.
Blower/Vacuum .......................... BV720r
Cultivator .............................. GC720r
Edger .................................. LE720r
Hedge Trimmer .......................... HS720r
Snow Thrower ........................... ST720r
Straight Shaft Trimmer .................... SS725r
Sweeper/Blower ......................... SB720r
Tree Pruner ............................. TP720r
Turbo Blower ............................ TB720r
WARNING; Read and understand operator's
manual for add-on prior to operation.
Removing the Cutting Attachment or Add-Ons:
1. Turn the knob counterclocl_vise to loosen (Fig. 6)1
2. Press and hold the release button (Fig. 8).
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link fM_ coupler (Fig. 6).
Installing the Cutting Attachment or Add-Ons:
WARNING; To avoic_ serious personal injury
and damage to the unit, shut unit off before
removing or installing add-ons.
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a work
bench.
1. Turn knob counterclockwise to loosen (Fig. 8).
iiiiiiiiiiiiiiiiiiiEz Li T ii # riiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiR ii tt i iiiiiiiiiiiiiii
Fig6
2. While firmly holding the add-on, push it straight into
the EZ-Link _ coupler (Fig. 7).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 8).
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiR_ieasei_0niiiiiii
iiiiit
3. Turn the knob clockwise to tighten (Fig. 8).
CAUTION: Lock the release button in the
primary hole anc_securely tighten the knob
Jbefore operating this unit,
CAUTION: The cutting attachment and
add-ons with the EZ-Link fM system are to be
used in the primary hole unless stated
other_ise in the specific add-ons ope_tor's
manual. Using the wrong hole could lead to
personal injury, or damage to the unit.
For edging when using the line head cutting attachment
with EZ-Link _"_models, lock the release button of the
cutting attachment into the 90_ edging hole or the 180_
edging hole(Fig. 8).