Manual

Onsomeunits,theD-handlemaybepre-installed.In
thiscaseyoumustloosenthewingnutandadjustthe
handletofit theoperator.Goto step4 iftheD-handleis
pre-installed.
INSTALLING AND ADJUSTING THE D-HANDLE
1. Remove the bolt, wing but and washer that were
installed on the D-handle for shipping.
2. Place D-handle the over the shaft housing and push
it on the boom (Fig. 1).
\\\
\
INSTALLING THE CUTTING SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed or if you ever need to
re-install it.
WARNING: Never operate the trimmer
without the cutting attachment shield in place
to prevent Serous persona njury.
1. Place the cutting attachment shield onto the shaft
housing above the clamp assembly (Fig. 3).
\\\\
\ \
Shaft Housing
Clamp
Fig. 1
3, Install the bolt, washer and wing nut. Tighten them.
4. If the D-handle was pre-installed, loosen the wing nut
just enough so it is movable.
5. While holding the unit in the operating position,
arrange or rotate the D-handle to the location that
provides you the best grip (Fig. 2).
6. Tighten the wing nut until the D-handle is secure.
\
\
\
\
2.
\ Shield
Fig. 3
Push the cutting attachment shield down to the top
of the cutting attachment assembly. Then rotate the
shield until its screw holes line up with the holes in
the cutting attachment. The shield guard should fit
into the recessed pocket (Fig. 4).
Fig. 2
.
/
Cutting Attachment
Cutting Attachment Shield
Fig. 4
Install the screws with a Phillips screwdriver (Fig. 5).
(4) Screws
Fig. 5
7