Manual

The supportbracketsmust
be assembledto theoutside
of the handlebarassembly.
Fig.2-3: Wheelin FREEWHEELposition
(wheeldrivepin throughwheelshaftonly).
STEP 4: INSTALL FORWARD
CLUTCH CABLE
1. Carefully unwrap the forward clutch ca-
ble(cable without an attached knob) from
its shipping position and slide the thin ca-
blewire (M, Fig.2-4) into the slot in the ca-
blebracket. Push the cableconnector (N,
Fig.2-4) upthrough the holein the bracket
until the groove in the connector snaps
into place.
2. Threadthe #10-24 hex nut (Z, Fig. 2-5)
halfway onto the screw (V) which runs
through the spring (W, Fig. 2-5).
3. Threadthe screw (V) into the cable ad-
juster (X).
Fig. 2.2: Attachhandlebar.
through the wheel shaft (L) only (not
through the wheel hub). The wheelshould
now spin freely (freewheel)on the wheel
shaft. Repeatwith the other wheel.
4. Usethe handlebarto roll the tiller to a
flat area.
IMPORTANT:Beforestarting the engine,
the wheels must beplaced in the WHEEL
DRIVEposition (pinsthrough wheel hubs
andwheel shaft). This procedure is
described in WheelDrivePins on page 10.
Fig. 2-4:/nstal/ing forward clutchcable bracketand cable.