Manual

2, Loosen,but do NOTremove,the hex nutfoundon the
rightsideof the brakeassembly,SeeFigure13,
3, Usinga feelergauge,setthe gapbetweenthe brake
discandthe brakepuckat ,011",
4, Reqightenthe hexnut loosenedearlier,
Seat Adjustment
WARNING:Before operating this
machine, makesure the seat is engaged
inthe seat stop, stand behind the
machine and pull back on seat until fully
engagedintostop.
1, Flipthe seatupas shownin Figure14,
2, Loosenthetwo seatadiustmentknobslocatedunder
the seat, SeeFigure14,
3, Slidethe seatforwardorrearward,then tightenthe
knobsto lockthe seatat thedesiredposition,Put the
seatdownto the operatingposition,
Set gap ,011
Figure 13
Hex Nut
Steering Adjustment
If the tractorturnstighterinonedirectionthan theother,
or if the balliointsarebeingreplaceddueto damageor
wear,the steeringdraglinksmayneedto beadiusted,
Adiustthedraglinksso thatequallengthsare threaded
into the balliointon the leftandright side:
1, Loosentheiam nut foundonthe draglinkat the rear
of the ballioint,SeeFigure15,
2, Removehex nuton the topof ballioint,SeeFigure15,
3, Threadthe balljointtowardtheiam nutto shortenthe
draglink,Threadthe ballioint awayfromtheiam nut
to lengthenthe draglink,
4, Replacehex nutandretightenthejam nut afterproper
adiustmentis achieved,
NOTE:Threadingthe balliointstoo far ontothe draglinks
will causethe fronttiresto "toe=in"too far,Propertoe=inis
between1/16"and5/16",
Figure 14
Fronttire toeqncan be measuredas follows:
1, Placethe steeringwheelinpositionfor straightahead
travek
2, Infrontof the axle,measurethe distancehorizontally
fromthe insideof the left rimto the insideof the right
rim,Notethe distance,
3, Behindtheaxle,measurethe distancehorizontally
fromthe insideof the left rimto the insideof the right
rim,Notethe distance,
4, The measurementtakenin frontof the axle shouldbe
between1/16"and5/16"lessthanthe measurement
takenbehindthe axle,Adiustif necessary,
Figure 15
19
NOTE:Threading the
bal joints too far onto
the drag linkswill cause
the front tires to "toe-in'
too far, Propertoe-in
is between 1/16"and
5/16".