Manual

AttachingDriveAdjusterBlock
The drive adjuster block is attached to the drive cable.
1. Remove bolt attached to the lower left handle.
2. Align the drive adjuster block with hole in handle. Its
curved side goes against the handle,
3. Secure drive adjuster block with the bolt previously
removed. See Figure 5.
Drive
Adjuster
Bolt
Figure 5
Grass Catcher
Insert frame
Grassl _
Ba
Grass Catcher
Assembly
Plastic
Channel
f
AttachingStarterRope
The rope guide is already attached to the right side of
the lower handle of your mower. See Figure 6.
1. With spark plug wire disconnected and grounded,
hold the blade control bar against the upper handle,
and pull the starter rope out of the engine.
2. Slip the rope through the rope guide as shown
below. Tighten the wing nut holding the rope guide
to the handle.
Figure 7
2. Slip the side openings on the plastic channel ofthe
grass bag over the hooks on the grass catcher
frame. Secure bag to the frame by working the six
plasticchannels.
IMPORTANT:Entire channel except the center top of the
bag attach from outside of bag. The center top of the
bag attaches from inside of bag. See Figure 7.
1 AttachingGrassCatcher
Blade Control Bar
_b WARNING: If using the grass catcher, the
hooks on the grass catcher must be firmly
_per Handle / seated on the chute pivot rod, and the rear
discharge door must rest firmly on top of the
grass catcher.
1. Lift the rear discharge door and place the grass
catcher on the pivot rod. Let go of the discharge
Starter "_'"_J "_'_\ Lower Handle/ door so that it rests on the grass catcher. See
Rope'_ _/ / Figure 8.
Wing Nut
Figure 6
AssemblingGrassCatcher
NOTE: If the grass catcher came pro-assembled,
proceed to the next section. If not, foflow the steps
below to assemble it before attaching to the mower.
1. Insert frame into grass bag with the black plastic
side on the bottom of bag. See Figure 7.
Grass
Catcher
Figure 8