Installation Sheet
6. When the ceiling is reached, measure 6" beyond the chain and cut off the excess wire.
Separate the leads and strip of approx. 1/2" of insulation from each lead. Twist the strands of wire together.
Push the leads and ground wire up through the screwcollar loop and nipple and into the outlet box.
7. Fasten the ground wire to the green or bare copper wire
in the outlet box or to the green screw on the crossbar.
WARNING
Never fasten the ground wire to the black or "hot" wire!
Failure to follow this instruction could result in
serious injury or death！
8. Fasten the rough fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut). Starting
about 1' below the fastener, tightly wrap the connection with electrical
tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
9. Connect the smooth fixture lead to the black wire in the outlet box.
Fasten the joined wires as in step 8.
10. Thread the SAFETY CABLE down through alternating links of chain.
11. Slide the canopy and ring up the chain to the outlet box. Secure the
canopy in place against the ceiling.
12. Thread a crimp-on cable clamp onto the SAFETY CABLE. Loop the
SAFETY CABLE through the fixture loop.
13. Thread the SAFETY CABLE back through the crimp-on cable clamp.
Pull cable snug and tightly crimp cable clamp in place.
DO NOT
OVER TIGHTEN THE CABLE AND CAUSE THE CHAIN TO SAG!
Remove excess cable approx 1/ 2" beyond the clamp.
14. Install the fixture on all cables.
15. Install the glass on socket use socket ring and socket sleeve with tool ring sleeve.
16. Install the lamps (light bulbs). NOTE: This fixture is rated for
Max 60 watt type B lamps or Early electric lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
17. Restore power to circuit at breaker or fuse.
Cable
electrical tape
approved fastener
(
wire nut
)
Wire nut
Green screw
Mounting screw
Hex nut
Nipple
Canopy
Mounting bar
Outlet box
Loop,
fasten
safety cable here
Ring
Chain
Screwcollar
Hook
Ring
Bulb
Sleeve
Glass
Ring sleeve
Allen wrench