Installation Sheet

11/29/20130122
7. Fasten the white fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut). Starting about 1' below the fastener, tightly wrap
the connection with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
8. Connect the black fixture lead to the black wire in the outlet box. Fasten the joined wires as in step 7.
9. Slide the canopy and screwcollar ring up the chain and secure the canopy to the ceiling.
10. Install the lamps ( light bulbs). NOTE: This fixture is rated for Max 60 watt type B, BA, C, CA lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
11.
Using the ball head screws and end balls, fasten the shade to the support arms
12. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)