Installation Sheet

4. Fasten the white fixture lead wire to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut). Starting about 1” below the fastener,
tightly wrap the connection with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the black fixture lead wire to the black wire in the
outlet box. Fasten the joined wires as in step 5.
6. Using the end nuts, fasten the fixture to the outlet box.
.
7. Install the 2 glass shades onto fixture between metal washer and plastic washer, then secure it with metal ring .
8. Install the lamps (light bulbs).
NOTE: NOTE: This fixture is rated for Max 60 watt type G40 or A lamps .
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
9. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)