Instructions / Assembly

2 / 2
7/20/2020
4. Fasten the white fixture lead wire to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut). Starting about 1” below the fastener,
tightly wrap the connection with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the black fixture lead wire to the black wire in the
outlet box. Fasten the joined wires as in step 5.
6. Using the end nuts, fasten the fixture to the outlet box.
.
7. Install the glass panels in the cage. Bend the tabs over the panels to hold them in place.
8. Install the lamps (light bulbs).
NOTE: NOTE: This fixture is rated for Max 60 watt type A-15 (fan) or B lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
9. Place the cage over the center pipe and secure in place with the ornament and finial.
10. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)