Installation Sheet

2/5/2015
2
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
4. Connect the black fixture lead to the black wire in the outlet box. Fasten the joined wires as in step 3
.
5. Using the end nuts, loosely fasten the fixture to the outlet box. Rotate and align the fixture as necessary. Tighten the end nuts.
6. Adjust the hex nut on the nipple so that 3/8" is exposed at the end. Thread the nipple into the hex coupling that is centered on the socket bracket.
Tighten the nut against the coupling.
7. Install the lamps ( light bulbs). NOTE: This fixture is rated for Max60 watt type A-15 (fan) lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
8. Place the center glass into the fixture.
Using the soft washer and the cap nut secure the glass in place.
9. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)