Installation Sheet

10/23/2014
2
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
4. Connect the black fixture lead to the black wire in the outlet box. Fasten the joined wires as in step 3
.
5. Fasten the canopy on ceiling use ball nut.
6. Place the mounting tabs on top of the support arms. Lift the shade up into the fixture. Using the ball head screws
and end balls, fasten the shade to the support arms
7. Install the lamps ( light bulbs). NOTE: This fixture is rated for Max
60 watt type B, BA, C or CA lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
8. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)