Instruction Manual

Page 2 of 3
FIGURE-02
FIGURE-03
Approved fastener ( wire nut )
Electrical tape
WARNING
Make sure that there is no exposed wire or strands
that could cause a dangerous short circuit!
4. Connect the black fixture lead to the black wire
in the junction box. Fasten the joined wires as in step 3.
5. Attach the the backplate to the mounting ring with wing and secure it with
flat head screw (See Figure 02).
6. Place the LED into the socket of the fixture.
NOTICE:
This fixture is rated for 4w LED.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
8. Restore power to the circuit breaker or fuse box.
7. Install the glass diffuser into place. (See Figure 03)
FLAT HEAD SCREW
BACK PLATE
GLASS DIFFUSER
WATTAGE LABEL