Instruction Manual

B7262 NOMAD 2LT VANITY INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
CAUTION
·
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH
ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.
· INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR
CERTIFIED FACTORY TRAINED TECHNICIAN.
· If an existing fixture is being replaced, remove it and note to which of the wires in the junction box the fixture was attached.
DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.
In regular circumstances the BLACK wire will be the "Hot" lead and the WHITE wire will be the "Neutral" or "Common" lead
A GREEN or BARE COPPER wire is the "Ground". In older buildings it is always good practice to reconfirm the polarity of the wiring
.
Page 1 of 3
NOTICE:
CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO
CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USE.
JUNCTION BOX
MOUNTING RING
WITH WING
MOUNTNG SCREW
FIGURE-01
NOTICE
· The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that
may occur. it must be understood that common sense, caution and care factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and caring of this lighting fixture.
· This fixture is designed to be mounted on a correctly installed standard round or octagon box or a through wiring box
with a plaster frame. The box must be securely mounted to the structure of the building. The mounting ring and hardware
supplied should be used. directly mounting the fixture to the junction box may make it impossible to correctly align the fixture.
GREEN SCREW
WALL
FIXTURE PREPARATION
1. Remove the fixture, parts and parts bag(s) from the carton.
NOTICE:
· Before discarding the carton, double check to
make certain that all parts are found.
FIXTURE INSTALLATION
1. Attach the mounting ring with wing to the juntion box using mounting screw. (the
green screw should face out). (See Figure 01)
3. Fasten the white fixture lead to the white wire in the junction box.
Fasten the wires together with an approved fastener (wire nut). Starting about
1" below the fastener, tightly wrap the connection with electrical tape so that the
connections seals the end of the fastener.
WARNING
Never fasten the ground wire to the black or "hot" wire!
Failure to follow this instruction could result in serious injury or death!
2. Fasten the ground wire to the green or bare copper wire in the junction box to
the green screw on the mounting ring with wing.