Installation Sheet
FIXTURE PREPARATION
1. Remove the fixture, parts and parts bag(s) from the carton.
NOTICE:
Before discarding the carton, double check to
make certain that all parts are found.
CAUTION
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH
ALL APPL ICA B LE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.
INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR
CERTIFIED F A C TO RY TRAINED TECHNICIAN.
If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached.
DO NOT SEPARATE ANY OTH ER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.
In regular circumstances the B L A CK wire will be the "Hot" lead and the WHITE wire will be the "Neut ra l" or "Common" lead
A GREEN or BARE COPPER wire is the "Ground". In older buildings it is always good practice to reconfirm the polarity of the wiring.
B7232 RIVINGTON SCONCE INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
Page 1 of 3
NOTICE
The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that
may occur. it must b e underst oo d that common sense, caution and care factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and caring of this lighting fixture.
This fixture is designed to be mounted on a correctly installed standard round or octagon box o r a through wiring box
with a plaster frame. The bo x must be securely mounted to the structure of the building. The mounting plate and hardware
supplied should be used. directly mounting the f ixt u re to the outlet box may make it impossible to correctly align the fixture.
NOTICE:
CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEM I CALS KNOWN TO THE STATE OF CALIFORNIA TO
CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USE.
FIGURE-01
FIXTURE INSTALLATION
1. Attach the mounting plate to the outlet box. (The green screw should face
against the wall).
3.
Fasten the white fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut). Starting about
1"below the fastener, tightly wrap the connection with electrical tape so that the
connections seals the end of the fastener.
JUNCTION BOX
MOUNTING PLATE
WALL
WARNING
Never fasten the ground wire to the black or "hot" wire!
Failure to follow this instruction could result in serious injury or death!
2. Fasten the ground wire to the green or bare copper wire in the outlet box of
the green screw on the mounting plate.
GREEN SCREW