Installation Sheet

2 / 2
2016/1/26
4. Fasten the white fixture lead wire to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1” below the fastener, tightly wrap the connection
with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the black fixture lead wire to the black wire in the outlet box.
Fasten the joined wires as in step 4.
.
6. To prevent water from flowing into the outlet box
put a bead of weatherproof caulking
or silicone sealant around the inside edge of the back.
DO NOT PLUG THE DRAIN HOLE!
7. Using the end nut and sealing washers,
Fasten the fixture back plate to the outlet box.
8. Install the glass into frame.
9. Install the lamps (light bulbs).
NOTE: This fixture is rated for Max 60 watt type B A lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
10. Install the frame onto back plate with the set screw.
11. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Outlet box
Green screw
Mounting ring
Lamp
Back plate
Screw
End nut
Nipple
Frame
Glass
Set screw