Installation Sheet

11/28/20132
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
5. Connect the black fixture lead to the black wire in the outlet box.
Fasten the joined wires as in step 4.
6. To prevent water from flowing into the outlet box, put a bead of weatherproof caulking or silicone sealant around the inside edge of back.
Leave a 1/2” gap at the bottom of back to allow condensed moisture to drain.
.
7. Fasten the fixture to the wall use ball nut and washer.
8. Assemble the glass on fixture. . Bend the tabs over the panels to hold them in place.
9. Install the lamps ( light bulbs). NOTE: This fixture is rated for Max 60 watt type B, BA, C or CA lamp.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
10. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Lamp
Mounting ring
Ball nut
Put sealant here
Glass panel
Knurled screw
Green screw
Outlet box
Sleeve
Holder
Socket
Screw & nut
Decorative latch
Knurled screw
Sealing washer
Mounting screw