Instructions / Assembly

7/6/2020
2
4. Fasten the white fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1' below the fastener, tightly wrap the connection
with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
5. Connect the black fixture lead to the black wire in the outlet box.
Fasten the joined wires as in step 4.
.
6. To prevent water from flowing into the outlet box, put a bead of weatherproof caulking
or silicone sealant around the inside edge of the back.
Leave a ½" gap at the bottom of the back to allow condensed moisture to drain.
7. Using the cap nut and sealing washer, fasten the fixture to the outlet box.
8. Lift the glass panels into position. Place the bottom edge in the trough.
Bend the tabs over the panels to hold them in place.
9. Install the lamps (light bulbs).
NOTE: This fixture is rated for 60 watt type B, BA, C or CA lamps
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
10. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)