Installation Sheet

11/28/20132
4. Fasten the white fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1' below the fastener, tightly wrap the connection
with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
5. Connect the black fixture lead to the black wire in the outlet box.
Fasten the joined wires as in step 4
.
6. Fasten the fixture to the wall use nut.
7. Install the lamps ( light bulbs). NOTE: This fixture is rated for Max 60 watt type B, BA, C or CA lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
8. Slide the shade into position.
Using the 2 end nuts removed during fixture preparation,
fasten the shade to the fixture back
9. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Shade
Screw
Hex nut
Green
screw
Mounting ring
Outlet box
End nut
End ball
Lamp