Installation Guide Owner manual

DIMM Installation Guide
Hewlett-Packard 1200 Printers:
IMPORTANT: Ensure the printer power is switched OFF, and then disconnect the printer power cord
from the AC wall outlet.
1. Remove the printer paper tray to allow easier repositioning of the printer during the installation (Figure 1).
2. Open the toner cartridge access door at the front of the printer (Figure 2).
Figure 1 Figure 2
Unsnap the printer panel at the rear of the printer (Figure 3), swing the panel away from the printer, and then 3.
unhook and remove the panel from the printer to allow access to the DIMM slot (Figure 4).
Figure 3 Figure 4
Document #50-70395-001 Rev. D Page 2 of 22