Instructions / Assembly

778-18138 / 00 09/19
IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW
THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Lea la traducción en Español en el manual.
NEED HELP? CALL 1-800-828-5500
Starter Rope Grip
Primer Bulb
Knobs
Handlebar
NO ASSEMBLY TOOLS REQUIRED
DIDN’T START?
Repeat the starting
instructions.
If the unit still fails to start,
refer to the operator’s
manual for additional
starting and troubleshooting
information.
Unscrew the oil fill plug. Pour the
entire container of oil into the oil fill
hole. Reinstall the oil fill plug.
NOTE: DO NOT overfill. Never
add oil to the fuel tank. DO NOT
mix oil with gasoline.
Slowly remove the fuel cap. Fill
the fuel tank. Reinstall the fuel
cap. Move the unit at least 30 ft.
(9.1 m) from the fuel container
and the fueling site before
starting the engine.
NOTE: Use fresh unleaded
gasoline (less than 30 days old).
7
8
Read the operator’s manual
thoroughly before operating
the unit. Follow all warnings and
safety instructions. This fast
guide is intended as a reference
for users that have already read
the operator's manual and are
familiar with the necessary safety
precautions.
Align the holes on the upper
shaft with the holes on the
middle shaft. Insert a bolt into
each of the aligned holes. Install
a washer onto each bolt. Install a
knob onto each bolt. Tighten the
knobs securely.
Pull the starter rope and run it
through the eye hook. Insert the
throttle cable and wire assembly
into the cable restraints on the
upper and lower shafts.
NOTE: DO NOT bend or pinch
the throttle cable or wire
assembly.
Position the upper shaft onto the
middle shaft. Make sure the “V”
bend in the handle is pointing up
(toward the front of the unit) and
that the throttle control is on the
right side when the operater is
standing in the operating
position.
1
6
4 5
Slide the middle shaft onto the
lower shafts.
NOTE: Keep the throttle cable
and wire assembly to the front of
the unit.
Align the holes on the middle
shaft with the holes on the lower
shafts. Insert a bolt into each of
the aligned holes. Install a
washer onto each bolt. Install a
knob onto each bolt. Tighten the
knobs securely.
2 3
ASSEMBLY
Oil Fill Plug
Fuel Cap
Throttle Control
Middle Shaft
Lower Shaft
Upper Shaft
On/Off Switch
Slowly press and release the
primer bulb 10 times.
1
STARTING
Stand in the starting position.
Hold the handlebar firmly with
one hand. Hold the starter rope
with the other hand. Use one foot
to hold the wheels in place. Tilt
the unit back slightly to bring the
blade off the ground.
2
Squeeze and hold the throttle
control.
3
Continue to hold the throttle
control. Pull the starter rope with
a controlled and steady motion
until the unit starts.
4