Product Manual

11Section 3 — ASSembly & Set-Up
CAUTION: Do not use any type of power tool (e.g.
impact gun or electric drill with nut driver attached)
when tightening the self-tapping bolts to attach the
seat bracket.
Figure 3-4
3. Position the seat assembly over the seat mounting bracket,
aligning the holes provided.
4. Install two shoulder bolts included with your hardware
pack and secure with two lock nuts. See Figure 3-5.
Wing Knob
Figure 3-5
Note: Make sure that the bolt’s shoulder is completely
recessed into the seat bracket when securing the lock nut.
5. Plug the safety harness on the seat, into the wiring harness
on the unit as shown in Fig. 3-6.
Note: Route the unit’s wiring harness out through the front
of the seat mounting bracket as shown in Fig. 3-6.
5. Tighten the socket head screw and lock nut using provided
hex key and a /” wrench or ratchet.
1
2
2
Figure 3-2
6. Slide the Pedestal cap down onto the tractor (1) and clip
into place. Secure the pedestal with the hex screw (2) from
the hardware pack. See 6. Slide the Pedestal cap down onto
the tractor (1) and clip into place. Secure the pedestal with
the hex screw (2) from the hardware pack. See Figure 3-3..
1
2
Figure 3-3
Attaching The Seat
If the seat for your tractor was not attached at the factory, follow
the applicable instructions below to attach it.
1. Remove the two self-tapping bolts factory installed on the
tractor and place the seat bracket in place over the holes.
See Figure 3-4.
2. Using a /-inch drive ratchet with a /” socket, secure the
seat bracket with the self-tapping bolts.
11