Manualshelf

Full Product Manual

ManualsBrandsTroy-Bilt ManualsGas Snow BlowersStorm Tracker 28 in. 277cc Two-Stage Electric Start Gas Snow Blower with Track Drive and Electronic 4-way Chute Control
12345678910
8 Section 3— ASSembly & Set-Up
Overhead Chute Control Assembly
Remove wing nut and hex screw from chute control assembly
and clevis pin and cotter pin from chute support bracket.
Position the chute assembly (forward-facing) over the chute
base. See Figure 3-3.
Figure 3-3
4. Place chute assembly onto chute base and secure chute
control assembly to chute support bracket with clevis pin
and cotter pin removed earlier. See Figure 3-4.
Figure 3-4
5. Finish securing chute control assembly to chute support
bracket with wing nut and hex screw removed earlier.
See Figure 3-5.
Figure 3-5
6. Insert the chute directional control rod into the support
bracket on the rear of the dash panel. See Figure 3-6
Figure 3-6