Product Manual B

8 Section 3— ASSembly & Set-Up
Chute Assembly
1. Remove cotter pin (a), wing nut (b) and hex screw (c) from
chute control head. Remove clevis pin (d) and bow-tie
cotter pin (e) from chute support bracket. See Figure 3-3.
Chute Control Head
Chute
Chute Support
Bracket
Chute Base
(a)
(c)
(e)
(b)
(d)
Figure 3-3
2. Insert control rod into the chute control head. Push rod as
far into chute control head as possible, keeping the holes in
the rod pointing upward. See Figure 3-4.
Figure 3-4
3. Place chute onto chute base and ensure chute control rod
is positioned under the handle panel. Install hex screw (c)
removed in Step 1, but do not secure with wing nut at this
time. See Figure 3-5.
(c)
Figure 3-5
4. Squeeze the trigger on the joystick and rotate the chute by
hand to face forward. The holes in the chute control input
will be facing up. See Figure 3-6.
NOTE: The chute will not rotate without squeezing the
trigger on the joystick.
Top View
Chute Control
Input
Joystick
Figure 3-6