Product Manual

Assembly & Set-Up

Assembly

Handle (All Models)

1. Place the shift lever in the Forward-6 position.

2. Observe the lower rear area of the snow thrower to be sure

both cables are aligned with roller guides before pivoting

the handle upward. See Figure 3-1.

Figure 3-1

NOTE: Make certain the cables are seated properly in the

roller guides. See Figure 3-2.

3. Secure the handle by tightening the plastic knob located

on both the left and right sides of the handle. Remove

and discard any rubber bands, if present. They are for

packaging purposes only.

Figure 3-2

Chute Assembly (Model 2410)

1. Position the chute assembly over the base. See Figure 3-3.

Figure 3-3

Contents of Carton

• One Snow Thrower • Two Replacement Auger Shear Pins • One Chute Assembly

• One Snow Thrower Operator’s

Manual

• One Product Registration Card • One Chute Control Rod†

• One Engine Manual

† If Equipped