Operating Guide

Tr oubleshooting

Problem Cause Remedy

Excessive vibration or noise when

the Attachment Control Lever is

applied.

1. One or more of the clutch bumpers is missing or worn.

2. Loose parts or damaged auger.

1. Replace the three clutch bumpers with replacement kit

part no. 753-08457.

2. Stop engine immediately and disconnect spark plug

wire. Check for possible damage. Tighten all bolts and

nuts. Repair as needed. If the problem persists, take unit

to an authorized service dealer.

Augers continue to rotate 1. Cable out of adjustment. 1. Adjust the auger control cable as shown in the

Maintenance Section under “Adjusting the Auger Drive

Cable”.

Unit fails to discharge snow 1. Chute assembly clogged.

2. Shear pin(s) sheared.

3. Foreign object lodged in auger.

4. Auger control cable out of adjustment.

5. Auger belt loose or damaged.

1. Stop engine and disconnect spark plug wire. Clean

chute and inside of auger housing with clean-out tool

or stick.

2. Replace shear pin(s).

3. Stop engine immediately and disconnect the spark plug

wire. Remove object from auger.

4. Adjust auger control cable.

5. Replace auger belt.