Installation manual GB/en X-AIRCONTROL FAM-RD TROX GmbH Heinrich-Trox-Platz 47504 Neukirchen-Vluyn Germany Phone: +49 (0) 2845 2020 +49 (0) 2845 202-265 E-mail: trox-de@troxgroup.com http://www.troxtechnik.com Product overview Fig.
Product overview Connections and interfaces Fig.
General information General information Complete documentation About this manual Installation and operating manual This operating and installation manual enables operating or service personnel to correctly install the TROX product described below and to use it safely and efficiently. This operating and installation manual is intended for use by fitting and installation companies, inhouse technicians, technical staff, instructed persons, and qualified electricians or air conditioning technicians.
Safety Copyright Safety notes This document, including all illustrations, is protected by copyright and pertains only to the corresponding product. Symbols are used in this manual to alert readers to areas of potential hazard. Signal words express the degree of the hazard. Any use without our consent may be an infringement of copyright, and the violator will be held liable for any damage. Comply with all safety instructions and proceed carefully to avoid accidents, injuries and damage to property.
Delivery and storage Correct use requires that both the transmitter module and the receiver module are placed in the same duct system, i.e. either in the supply air duct or in the extract air duct. FAM-RD must not be used outdoors. Risk of damage to property due to foreign matter and liquids! Residual risks Foreign matter and liquids that get into the unit may damage the electronic parts. NOTICE! – – A power failure will interrupt data transmission.
Technical data Transport Technical data If possible, take the product in its transport packaging up to the installation location. Do not remove the protective wrapping until just before installation. Dimensions Storage For temporary storage please note: Leave the product in its packaging and do not expose it to the effects of weather. Store the product in a dry place and away from direct sunlight. Temperature –10 °C to +70 °C, humidity 90% max.
Installation Fixing the antenna mounting bracket Installation General installation information Fig. 6: Fixing material (not included in the supply package) Fig. 4: Positioning Please note: All modules that should communicate via radio have to be installed in the same duct system, i.e. either in the supply air duct or in the extract air duct. Place the antenna at least 1 m away from control dampers, shut-off dampers and measuring devices.
Electrical connection Fig. 9: Insert the antenna so that it locks into place Electrical connection General information Connecting the power supply Fig. 10: 1:1 Modbus connection Personnel: Skilled qualified electrician Wiring examples Supply voltage Ä ‘Technical data’ on page 6 Do not connect more than 5 RadioDuct modules in series using the double terminals. Note that a series connection with a zone master or zone module requires 24 V AC supply.
Electrical connection Fig. 12: Connection to zone master – data connection (Modbus) and power supply with X-AIRPCASE230 V Fig. 14: Connection to zone module – data connection (Modbus) and power supply with X-AIRPCASE230 V Complete documentation Installation and operating manual Zone module This document is the installation manual for the product. For more information on commissioning and operation please refer to the installation and operating manual. You can download the manual from our website www.
X-AIRCONTROL FAM-RD
