Operation Manual

EN 7
tower fan TVE 36 T
Night mode
In night mode, the device gradually changes the fan stage
automatically depending on the selected fan stage. You can set
the fan stage manually from 1 to 3 in this mode.
• When set to fan stage1 in night mode, the device keeps
running at the first stage of natural wind mode.
• When set to fan stage2 in night mode, the device keeps
running at the second stage of natural wind mode. After
30minutes the device automatically switches over to the
first stage of natural wind mode.
• When set to fan stage3, the device keeps running at the
third stage of natural wind mode. After 30minutes the
device automatically switches over to the second stage of
natural wind mode. After another 30minutes the device
automatically switches over to the first stage of natural
wind mode.
To activate night mode, please proceed as follows:
1. Press the MODE button(15) until the = night mode LED
lights up among the operating mode LEDs(13).
ð The device runs in night mode.
2. Press the fan stage button(14) to switch between the fan
stages.
ð The selected fan stage is indicated by the fan stage
indication(11).
Setting the timer
The timer has two modes of operation:
• automatic switch-off upon expiry of a preset number of
hours
• automatic switch-on upon expiry of a preset number of
hours
The number of hours can be set to 1h, 2h, 3h, 4h, 5h, 6h or
7h
The function can be set in all operating modes. It can be
activated both during operation and in standby mode.
Automatic switch-on
ü The device is switched off.
1. Press the TIMER button(9) until the desired number of
hours is displayed by the Hours LEDs(12).
ð The timer setting equals the desired number of hours.
ð The device switches on automatically after the set
number of hours has elapsed.
2. To delete the setting, press the TIMER button(9)
repeatedly until the Hours LEDs(12) no longer indicate any
value.
Automatic switch-off
ü The device is switched on.
1. Press the TIMER button(9) until the desired number of
hours is displayed by the Hours LEDs(12).
ð The timer setting equals the desired number of hours.
ð The device switches off automatically after the set
number of hours has elapsed.
2. To delete the setting, press the TIMER button(9)
repeatedly until the Hours LEDs(12) no longer indicate any
value.
Memory function
If you switch the device back on from standby mode or after a
power failure, the settings selected for the last used operating
mode are saved.
Any activated timer will not be saved in the device.
Using the oscillation function
By means of the oscillation function you can achieve consistent
ventilation.
ü The device is switched on and operating.
1. Press the OSCbutton(8) to activate the oscillation
function.
ð The oscillation function is activated.
ð The fan body rotates to and fro by up to 60°.
2. Press the OSCbutton(8) to deactivate the oscillation
function.
ð The oscillation function is deactivated.
ð The device stops oscillation at the desired position and
continues to run in the selected operating mode.