Operation Manual

13 EN
dehumidifier TTK 40 E
3. Allow the filter to dry completely. Do not insert a wet filter
into the device!
4. Reinsert the air filter into the device.
5. Press the FILTER button(15) to reset the FILTER RESET
LED(14).
Emptying the condensation tank
When the condensation tank is full or not inserted correctly, the
device stops dehumidification operation and switches itself off.
The TANK FULLindication (12) is illuminated.
1. Take the condensation tank out of the device.
2. Empty the condensation tank over a drain or sink.
3. Rinse the tank with clear water. Clean the tank regularly
using a mild cleaning agent (no detergent!).
4. Refit the condensation tank into the device. Make sure not
to damage the float when inserting or removing the
condensation tank.
ð In doing so, make sure that the float is positioned
correctly.
ð In doing so, make sure that the condensation tank is
inserted correctly, for otherwise the device cannot be
switched back on.
Activities required after maintenance
If you want to continue using the device:
• Leave the device to rest for 12to24hours, so the
refrigerant can accumulate within the compressor. Wait
12to24hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
• Reconnect the device to the mains.
If you do not intend to use the device for a considerable time:
• Store the device according to the Storage chapter.