Operation Manual

EN 14
cordless baton screwdriver PSCS 10-3,6V
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug of the charger with wet or
damp hands.
• Switch the device off.
• Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
• Allow the device to cool down completely.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Cleaning
The device should be cleaned before and after each use.
Note
The device does not have to be lubricated after
cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
• Clean the device with a soft, damp and lint-free cloth.
Ensure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
• Dry the device with a soft, lint-free cloth.
• Dry the bits with a soft, lint-free cloth.
• Remove any drilling dust and, if applicable, wood chips
from the tool holder.
• Keep the connecting terminals on the device and charger
clean.
• Keep the ventilation openings free from dust deposits to
prevent overheating of the motor.
Disassembly
Battery removal and disposal
1. Completely discharge the battery by letting the device run
until the motor stops.
2. Loosen the 5screws at the handle(6).
3. Open the housing.
4. VersionA (without plug connection): Hold onto the
battery(15) and disconnect the wiring by means of a wire
cutter. Insulate the severed wire ends of the battery with
tape to prevent a short circuit.
VersionB (with plug connection): Hold onto the
battery(15) and disconnect the plug connections of the
wiring.
6
15
5. Dispose of the battery and the device as described in the
Disposal chapter.