Operation Manual

11 EN
cordless baton screwdriver PSCS 10-3,6V
Operation
Tips and notes on handling the cordless screwdriver
General information:
• Check the tool in the bit holder for correct fit before every
application.
• The centre position of the clockwise / counter-clockwise
rotationswitch (lock) is suited for work breaks or (drill) bit
exchange.
Screws:
• In case of soft wood, screws can be screwed in without
pre-drilling.
• In case of hard wood or large screws, it is recommended
to use a drill for pre-drilling.
• When using countersunk screws, the drill hole should be
countersunk beforehand.
• Especially smaller screws and bits may be damaged when
selecting an excessive torque and / or speed at the tool.
Drilling in general:
• Take short breaks regularly during drilling. When doing so,
take the drill bit out of the drill hole so that the drill bit can
cool down.
• Secure the workpiece in a tensioning device or vice.
• Use a suitable aid to mark the intended location of the drill
hole.
Drilling in metal:
• Use suitable metal drill bits (e.g. drill bits made of high-
speed steel (HSS)).
• For larger drilling diameters, use a smaller drill bit for pre-
drilling.
• Metal drill bits may also be used for drilling in plastic.
Drilling in wood:
• Use drill bits suitable for wood.
• Place a block of wood under the workpiece or drill in from
both sides so that the wood cannot break off when it is
being drilled through.
• Use a wood drill bit with centring tip. For deep drill holes,
use an auger bit; for large drilling diameters, use a
Forstner bit.
Selecting the rotational direction
Note
To avoid damaging the gear, only change the rotational
direction when the device is at a standstill.
The motor's rotational direction can be changed by means of
the switch for clockwise / counter-clockwise rotation(5).
1. Press in the switch for clockwise / counter-clockwise
rotation(5) on the side to which the motor shall rotate.
I. II.
5
I. Screwing in II. Unscrewing
2. Carry out a short test run to see whether the rotational
direction matches the intended application. A wrong
rotational direction may damage the tool and / or
workpiece.
3. If required, set the switch for clockwise / counter-
clockwise rotation(5) to centre position (lock) to block the
on / off switch(12).