Operation Manual

6 Operating manual – Condenser dryer DH 15 AX EN

Danger!

A falling device can cause injuries! Always utilize the

help of another person to transport and assemble the

device. Never stand below the device when suspended

in the air. Ensure adequate stability of the device's wall

fixing.

Behaviour in the event of an emergency

1. Disconnect the device from the mains power in an emergen-

cy.

2. Do not reconnect a defective device to the mains power.

Always utilize the help of another person to transport and assem-

ble the device. To lift the device, use a forklift or an elevating truck

as appropriate.

Observe the following instructions:

• When assembling the device, keep a sufficient distance to

heat sources.

• When assembling the device, especially in wet areas, secure

the device locally with an RCD (Residual Current protective

Device) which complies with the appropriate regulations.

• Ensure that extension cords are completely unrolled.

• Ensure that power supply's voltage and current comply with

the specifications on the device's nameplate.

• When assembling the device, observe the minimum distance

from adjacent walls or other objects as described in the Tech-

nical Data chapter.

Assemble the device as follows: Check the condensation drain

hose for proper fit and adjust the hygrostat to the desired humidity

level, before you put the protective housing back on the device.

Transport, assembly and preparation for start-up