Operation Manual

2 Operating manual – Condenser dryer DH 15 AX EN

Description of the device

This device uses the principle of condensation to automatically

dehumidify rooms.

The fan sucks damp room air through the air inlet (5), the air

filter (7), the evaporator and to the condenser located behind it.

The air is cooled at the cold evaporator until it is below the dew

point. Water vapour contained in the room air precipitates on the

evaporator fins as either condensation or frost. The dehumidified,

cooled air is rewarmed at the condenser and blown out at a tem-

perature of approx. 5 °C above room temperature. The drier air,

thus conditioned, mixes with the air in the room via the air

outlet (3). The humidity in the room where the device is positioned

is reduced as air constantly circulates through the device.

Depending on the air temperature and the relative humidity, the

condensed water either drops continuously or only during the

defrost phase into the condensation tray. The condensate is dis-

charged from the device via a pre-assembled condensation drain

hose (4).

To set the desired humidity level, a hygrostat with control dial (6)

is provided in the device's interior. This control dial can be easily

accessed once the protective housing (1) has been removed.

The device can reduce the relative humidity of a room by up to

approx. 30 %. Because of the heat radiation which is tied up in

operation, the room temperature can rise by approx. 1-3 °C.

Device depiction

Scope of delivery

• Condenser dryer DH 15 AX

•Air filter

• Condensation drain hose

• Operating manual

• Screws and universal dowels (size 6 mm)

Information about the device

No. Operating element

1 Protective housing

2 Operation indicator

3 Air outlet

4 Hose connector for condensation drain hose (inside the device)

5 Air inlet

6 Control dial hygrostat (inside the device)

7 Air filter