Operation Manual

12 Operating manual – Condenser dryer DH 15 AX EN

Activities for before the start of maintenance

1. Do not touch the mains plug with wet or damp hands.

2. Before any work, detach the mains plug!

Maintenance tasks at the electrical equipment or

the air-conditioning technology must only be car-

ried out by specialist companies for cooling and air-

conditioning or by TROTEC

Visual check for dirt in the inside of the device

1. Remove the air filter (see chapter Cleaning the air inlets and

the air filter).

2. Shine a torch through the opening of the device.

3. Check the inside of the device for dirt.

4. If you can detect a thick layer of dust, proceed as follows:

– Remove the mains plug from the mains socket.

– Remove the protective housing.

– Clean the device's interior with a lint-free, soft cloth.

– Put the protective housing back on.

– Plug the mains plug back into the socket.

5. Put the air filter back in.

Cleaning the housing

1. Use a soft, lint-free cloth for cleaning.

2. Dampen the cloth with clean water. Do not use sprays, sol-

vents, alcohol-based or abrasive cleaners to dampen the

cloth.

Cleaning the air inlets and the air filter

Caution!

Ensure that the air filter is not worn or damaged. The

corners and edges of the air filter must not be rounded

or misshaped.

Before reinserting the air filter, ensure that it is dry and

is not damaged!

Read the chapter Maintenance intervals and replace the

air filter in due time!