Operation Manual

EN Operating manual – Condenser dryer DH 15 AX 9
Positioning the condensation drain hose
Note:
The condensation drain hose is already installed when the device
is delivered.
1. Ensure that the condensation drain hose is properly connec-
ted to the device and is free of damage.
2. Depending on use, position the end of the condensation drain
hose as follows:
– Position a sufficiently large container (at least 20 litres) be-
side the device and insert the hose end. Check the fill level
of the container regularly.
– Position the end of the condensation drain hose above a wa-
ter drain. For larger distances, a longer hose of the same
type can also be used.
3. Ensure that the condensation drain hose always descends.
Switch device on
1. Ensure that the condensation drain hose has been laid and
connected properly. Do not create tripping hazards.
2. Ensure that the condensation drain hose is not bent or
jammed and that there are no objects on the condensation
drain hose.
3. Ensure that the condensation can run off properly.
4. Insert the mains plug into a properly secured mains power
socket. Do not create tripping hazards.
5. Check whether the operation indicator light (2) lights up red.
Room humidity adjustment
1. Remove the front screw from the protective housing and take
off the enclosure.
2. Set the desired humidity level via the control dial (4) of the hy-
grostat.
3. Put the protective housing back on the device and tighten the
screw.
Automatic defrost
If the room temperature is below 15 °C, the evaporator becomes
covered in frost during dehumidification. The device then carries
out an automatic defrost. The duration of the defrost can vary.
• Do not turn off the device during the automatic defrost. Do not
remove the mains plug from the mains socket.
Shut down procedure
1. Do not touch the mains plug with wet or damp hands.
2. Remove the mains plug from the mains socket.
3. Remove the condensation drain hose and any residual fluid
from it.
4. Clean the device, and especially the air filter, according to
chapter Maintenance.
5. Store the device according to chapter Storage.
12x1 mm