Operation Manual
EN 6
Operating manual – humidifier B 24 E / B 25 E
4. Add a few drops of scented oil onto the filter ring(16) in
the scented oil reservoir.
Note:
Make sure that no scented oil drops onto the fan or the
electronic equipment below as this may damage the
device.
16
5. Put the air grid back on the device and fasten the
attachment by turning clockwise.
Connecting the power adapter
• Plug the power adapter cable into the device's mains
connection.
• Plug the power adapter into a properly fused mains socket.
Operation
• Avoid open doors and windows.
Operating elements
8 9 10 11
12131415
No. Designation Meaning
8 Filter LED Filter change indication
9 Dimmer button Dimming the LEDs
10 Hygrostat button Selection button for the humidity
level 45%, 50%, 55%, 60%,
100% (continuous operation)
11 No water LED Refill water tank indication
12 Humidity level LEDs Indication of the set room
humidity level
13 Power button Switching the device on or off
14 Speed button Setting the fan speed
15 Fan speed LEDs
1
2
3
4
Fan speed indication
Stage 1 = low (night mode)
Stage 2 = medium
Stage 3 = high
Stage 4 = maximum
Switching the device on
1. Make sure that the tank has been filled with water.
2. Make sure that the device is neither damp nor wet on the
outside. Otherwise wipe it dry.
3. Press the power button(13).
ð The blue LEDs light up.
Note:
If the set humidity level is already present in the room, the blue
Humidity level LED(12) will flash for approx.5seconds. Then
motor and fan will switch off.