Operation Manual
5 EN
Operating manual – humidifier B 24 E / B 25 E
2. Insert the SecoSan
®
Stick10 into the provided retainer on
the bottom of the water tank.
3. Insert the evaporation filter into the water tank.
4. Fill the water tank with fresh drinking water.
ð Stop approx.5cm below the edge of the water tank.
ð The evaporation filter may get wet.
5. Place the upper part correctly onto the water tank.
ð The electronic equipment and the fan in the upper part
must not get wet.
6. When setting up the device, ensure a sufficient distance to
walls and other objects. The air inlet and outlet must not
be obstructed or covered, e.g. by curtains.
7. Plug the mains plug into a sufficiently fused socket.
ð The device is ready for operation.
Scent option
Additionally, the device offers the possibility to distribute a scent
during operation.
Use standard scented oil. Proceed as follows to use the scent
option:
ü The device is switched off and the power cable is
disconnected from the mains.
1. Unscrew the attachment for the air grid (1) by turning
counter-clockwise.
2. Remove the air grid.
ð The scented oil reservoir is open.
16
3. Rinse the filter ring (16) under running water if you use
different scented oils in succession.