Installation Manual

Auto leveling and set up the Z offset
Connect the power supply and
turn on the switch to perform
interface operations.
The print head returns to home position and stops at the lower left corner of the hot bed. It moves normally
during the process, so can proceed to the next step.
this step several times to get the average value, and raise or lower the height of the hot bed by rotating the nuts at the four
corners of the hot bed.
Selecting the 0.1mm button means that each time the nozzle go down, the distance is 0.1mm. For example, if you want to lower
the nozzle 1mm, you need to click the button 10 times.
Done !
If you feel resistance
when dragging the
white paper, it proves
that the distance is
appropriate, then click
the green button to
save Z offset.
Z offset
3