User Manual

Step 15 Install Filament Feeder
Parts:
42 Stepper motor – 1pcs
Feeding gear (with grub screw in it)– 1pcs
Extrution clip - 1pcs
Extrution seat – 1pcs
M3-22mm – 2pcs
M3-16mm – 1pcs
M5-10mm Hex screw – 1pcs
Spring – 1pcs
 Insert the feeding gear to the motor shaft and
them tighten up .
 Place the Extrution seat and motor to the bracket
as shown in the picture, secure them using 2pcs
M3-22mm screws.
 Put one M5-10mm hex screw and spring
between extrution clip and extrution seat , next
secure the extrution clip with motor using M3-
16mm screw.