User Manual

Level Instruction

In order to better printing , we also need to level the print bed or the

filament may not adhere to the bed that result in poor printing quality

and can not print.

1, Please clean the nozzle to make sure there are no remained

material before leveling.

2, Turn on the power, press the menu button , select‘Quick

setting’ , then select ‘Home all’ , the printer start homing. (Figure 1)

3, After Home all , press menu button to select ‘Disable stepper’,

then you can move the axis manually. (Figure 2)

4, Move the extruder and platform manually, observe the distance

between nozzle and four corners of the platform and to assure the

same distance of them . If higher or lower , please adjust the thumb

nuts below the bed frame.

Note: You can put one A4 paper between the nozzle and platform,

pulling the paper backwards and forwards, if it happens to have a

little bit of resistance, that is well spaced.

Figure 1

Figure 2

Adjust the thumb nut

Move platformMove extruder

Observe distance