Installation Instructions

LED BUTTON
OPERATION INSTRUCTIONS
ADDRESSING INSTRUCTIONS
The TWS-1 can be mounted directly on any wall
surface with appropriate fasteners to secure. (*Do not
place TWS-1 inside metal enclosures or else the signal
may be affected.)
Fasten the antenna to the wireless station
Connect the wireless station to the Hydro-X Pro’s
sensor port to connect sensors or the device port to
connect device modules wirelessly.
There is a manual push-button and a LED indicator on
the TWS-1 antenna side. The button can be used to pair
the wireless station to the controller or to reset the
addressing between sensors or device modules and the
TWS-1 itself.
●
make sure that your HCS-2 controller is updated to
the most recent firmware.
●
Connect the TrolMaster Wireless Station (TWS-1) to
the Hydro-X Pro (HCS-2) Sensor port.
●
●
Press and release the button quickly on the TWS-1 to
pair the TWS-1 to the main controller. A “pairing
successful” message will appear on the HCS-2 display
when successful.
●
●
LED Indication Message
No Light No Power
Stand ByFlashing Green
Pairde to ControllerSolid Green
How to add the TWS-1 to the Hydro-X Pro
TWS-1
0605
Hydro-X Pro Control System
01:30pm Jan 15,2022
Wireless Station
Light
Temp
Humid
CO2
Devices
Advanced
Historical Chart
Zone1 Wireless Station is
Added
OK