User's Manual

Two green LEDs – Optimal signal enhancement
One green, one yellow LED – Very good signal enhancement
Two yellow LEDs – Good signal enhancement
Any red LEDs – Poor signal enhancement
Importance
Unit must first be turned on without antennas connected for system calibration. Ensure
that LED light on amplifier unit is green before connecting antennas. Amplifier unit must
remain on while connecting antennas.
o Step 4. Position the Rear antenna
Important
The Rear antenna needs to be installed at least 20 cm (or approximately 8-in) away from
all persons during normal operation to comply with the FCC’s radiofrequency radiation
exposure requirement.
Position the Rear antenna within vehicle towards bottom of rear window
on passenger side. Optimal position is 1-in. from bottom of window.
Avoid contact with any metallic materials - including window heating
coils.
Do not use adhesive backing to permanently affix antenna until Step 6.
For magnet mounted antenna, start by positioning the antenna outside,
on top of the trunk, on the driver side. Move slowly toward the
passenger side to locate the optimal position.
Connect the Rear antenna to amplifier unit.
Note
Position the Rear antenna so that cord is hanging from bottom. There is only one
location where Rear Antenna can be connected to Amplifier Unit.
o Step 5. Position the Front antenna
Important
The Front antenna needs to be installed at least 20 cm (or approximately 8-in) away from
all persons during normal operation to comply with the FCC’s radiofrequency radiation
exposure requirement.
Position the Front antenna within the interior of vehicle, above driver
seat with adhesive pointed away from cell phone user.