User's Manual

IMPORTANT: For optimal performance, Rear Antenna should be mounted
vertically. Connections to Amplifier Unit are specific to the Antennas.
Step 5. Position Small (Patch) Antenna - Position the Small (patch) Antenna as close
to, and with the best unobstructed view to, where the cell phone would normally be
used. Avoid placing this Antenna behind any metallic objects (ie. mirror in sun visor).
Do not make contact with any metal surface. Connect Small Antenna to Amplifier Unit.
IMPORTANT: Connections to Amplifier Unit are specific to the Antennas.
For optimal performance, do not affix Small Antenna to the front windshield.
Step 6. Achieve Optimal Enhancement - Once your LED is Green, you may
permanently affix both the Rear and Small Antenna. If LED is Yellow, adjust
the position of the Rear Window Antenna until the LED is Green.
Green LED – Optimal signal enhancement
Yellow LED – Good signal enhancement
Red LED – Poor signal enhancement
Step 7. Quick System Check - Put your cell phone antenna directly next to the Small
Antenna. See how many signal strength bars you have. Next, turn the system off (either
turn vehicle off or unplug Unit). You should notice a decrease in signal bar strength. The
exception is if you are in an area where, with the system off, your phone is at full signal
strength. Please note when you turn the system on, if your phone is receiving maximum
signal strength, you will not see a difference. In order for this quick test to work, you
will need to test unit in a less than maximum signal strength area.
© 2005 Richardson Electronics, Ltd. — Rev. 2
15